cryarrow88
User Name: You need to be a registered (and logged in) user to view username.
Total Articles : 0
https://www.g28carkeys.co.uk/fiat-car-key-replacements-near-me/
Reasons Your Fiat 500 Key Fob Wont Work A key fob with the fiat 500 number is a handy way to open the doors and start the car There are many reasons the fob may stop working This could be due to a dead coinbattery or water damage issues with the receiver module and interference This listing is for an NEW replacement Fiat Flip Key Remote that looks like the Ilco brand It needs to be professionally programmed click here to search for local locksmiths for your vehicle Includes lock unlock and trunk buttons Dead Coin Battery The most common reason the 500 key fob wont function is due to a dead battery Modern key fobs only have limited operating range and must be within a few inches of your vehicle in order to work If youre far from your vehicle and you press the key fob button the car will not respond and will display a Key Fob Not Detected message in the instrument cluster If this happens simply replace the battery on your coin cell Part number CR2032 by a new one from a reputable brand like Panasonic Duracell or Energizer They are typically available in your local hardware store or on the internet You can test the battery on your coincell by pressing the buttons while standing near your Fiat 500 The car will blink its parking lights and the key fob should work the lock and unlock switches If your fobs key isnt working even after replacing the battery it could be water damage that prevents it from communicating with the module inside your vehicle Water damage can occur in many ways such as simply splashing or submerging the key fob saltwater at the beach If fiat key fob replacement think your fob was exposed to water place it in a rice bag to draw out the moisture If this does not work youll have to get your fob replaced by an auto locksmith or a dealer Water Damage Water damage can happen if you immerse the fob into the ocean or wash it in a machine Saltwater is especially dangerous to the fobs circuit board causing it to short out and eventually end up dying Its not a good idea to get the fob wet however but dont give it up if you accidentally drop it in the water or dont remove it from your pants pocket First remove the battery from the fob Before replacing the battery clean the electronic chip using isopropyl or similar products Then test the fob to verify if it is working If the fob doesnt work it may have to be reprogrammed This is typically done by a professional or dealer auto locksmith If the key is newer and has not been programmed to your car It is likely that it needs to be replaced completely A professional locksmith for automotive can carry out this simple task The locksmith will need the key to be cut to match your vehicles ignition The locksmith will also have to reprogram your fob into the vehicles system This is a simple and affordable process that can usually be completed the next day Receiver Module Issues One of the simplest reasons why your 500 key fob may stop functioning is because its out of range The remote has a maximum range of 30 feet which means when youre too far from your car it wont respond to your commands This can be easily fixed by moving closer to your vehicle until it begins responding If your fob doesnt work after you replace the coin battery also known as a button watch or button It could be due to a problem with the internal circuit board In the majority of cases reprogramming your fob will solve the issue You can find the procedure for the majority of vehicles on YouTube or in the owners manual You may have to replace the metal retaining clips that hold the coin battery in place If they lose tension it can prevent the coin battery from sitting properly and this will cause the remote to malfunction In rare instances the fob may be out of alignment with your vehicle because due to hardware or software issues You can fix this issue by visiting your local dealer or autolocksmith to reprogram your key fob In certain instances they may need to reinstall the program in your body control module as well Interference In addition to a dead coin battery the key fob may not be able to receive or transmit an signal due to interference This can occur when the keyfob is located in close proximity to a radio transmitter such as a cell phone or radar detector The key fob could not function because of a problem to the buttons water damage or damage to the internal chips If your key fob suddenly stopped working or youve tried everything at home to fix it eg You may have a faulty 500 receiver module If youve tried replacing it with a battery reprogramming it or using a spare key fob The receiver module located under the dashboard receives radio frequency signals from your key fob It converts the signals into electronic commands which are then processed by the vehicle Fortunately theres an easy way to reset all onboard systems in your 500 device including the key fob Disconnect the battery for 15 minutes by removing first the negative cable then the positive cable Reconnect the battery This will eliminate any residual electricity and restart the cars computers This can help get your key fob working again If the problem persists you should speak with an expert certified technician They will be able diagnose the exact cause of problems
